# i3status configuration file.
# see "man i3status" for documentation.

# It is important that this file is edited as UTF-8.
# The following line should contain a sharp s:
# ß
# If the above line is not correctly displayed, fix your editor first!

general {
    output_format = "i3bar"
    colors = true
    interval = 5
    color_good = "#A5DF00"
    color_bad = "#6E6E6E"
    color_degraded = "#FF4000"
}

#order += "ipv6"
#order += "run_watch DHCP"
order += "run_watch VPN"
order += "ethernet _first_"
order += "wireless _first_"
order += "load"
order += "disk /"
order += "battery all"
order += "volume master"
order += "tztime local"

wireless _first_ {
    format_up = "   %essid (%quality) %ip "
    format_down = "   "
}

ethernet _first_ {
    format_up = "   %ip (%speed) "
    format_down = "  "
}

battery all {
    format = " %status %percentage (%remaining) "
    last_full_capacity = true
    integer_battery_capacity = true
    status_chr = "  "
    status_bat = "   "
    status_full = "   "
    threshold_type = percentage
    low_threshold = 10
}

run_watch DHCP {
    pidfile = "/var/run/dhclient*.pid"
    format_down = " dhcp "
}

run_watch VPN {
    pidfile = "/var/run/vpnc.pid"
    format = "  "
}

tztime local {
    format = "   %d.%m.%Y %H:%M "
}

load {
    format = "   %1min %5min "
}

disk "/" {
    format = "   %avail "
}

volume master {
    format = "   %volume "
    device = "default"
    mixer = "Master"
    mixer_idx = 0
}